This is a Battle Werx RMR-cut slide for Glock 26 subcompact pistols. Machined from 17-4 PH stainless steel billet, it features Battle Werx’s signature top serrations and a sealed RMR optic cut for durability. The slide is finished in salt-bath nitride for corrosion resistance and reduced glare.
The slide is designed for Glock 26 Gen 3 and Gen 4 models. It retains all factory specifications for reliability, with no modifications to the barrel or recoil spring assembly required. The RMR cut is machined to accept Trijicon RMR optics without additional plates.
Finish is applied after machining and fitting. Slides are hand-inspected for tolerances before nitride treatment. Minor fitting may be required for optimal performance with aftermarket barrels or recoil springs.
Sergei Volkov’s shop notes
Fitted this to a Gen 4 Glock 26, noticed the rear sight dovetail sits slightly tighter than standard—had to adjust the sight press just a hair to avoid marring the finish. The RMR cut itself is clean, no burrs, but the recoil lugs required light hand-fitting on this particular frame, nothing unusual for aftermarket slides. Cerakote held up well through the fitting, no flaking at the slide rails.
Tested: 1010 rounds bench-cycled. Pocket tolerance measured: within 0.0008″ on this batch. Weight (actual): 8 oz on shop scale. Units shipped from Las Vegas in May 2026: 70.
Reviews
There are no reviews yet.