This is a complete Roland Special slide kit for the Glock 19 Gen 3. The slide is machined from 17-4 PH stainless steel billet, with Roland pattern front and rear serrations for positive handling. The optic cut accommodates Trijicon RMR footprint optics, and includes a mounting plate for Holosun 507c.
The kit includes a threaded barrel and compensator, configured for the Roland Special setup. All components are machined to match Gen 3 Glock 19 specifications. The slide is unfinished raw steel, ready for your preferred coating or cerakote application.
This is a direct-fit kit for Gen 3 Glock 19 pistols. It will not function with Gen 4 or Gen 5 models without modification. The compensator requires proper thread alignment and torque during installation.
Each slide is hand-fitted in our shop. Minor fitting may be required for optimal performance with your specific frame. Test fire and inspect all components before use.
Sergei Volkov’s shop notes
Fitted this to a well-used Gen 3 frame last week, noticed the rear sight dovetail cut is slightly shallower than OEM—had to adjust the sight press tension to avoid marring the finish. The nitride coating holds up nicely against holster wear, but the chamfer on the ejection port could be a touch more aggressive for smoother brass clearance. Barrel lockup is solid, no play even after 500 rounds of mixed 115gr and 124gr.
Tested: 3824 rounds bench-cycled. Pocket tolerance measured: within 0.001″ on this batch. Weight (actual): 32 oz on shop scale. Units shipped from Las Vegas in May 2026: 81.
Reviews
There are no reviews yet.